Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the Grass Catcher
1.
Follow steps below to assemble the grass catcher. Make certain bag is turned
right side out before assembling (warning label will be on the outside).
a.
Place bag over frame so that its black plastic side is at the bottom.
b.
Slip plastic channel of grass bag over hooks on the frame. See Figure
7.
2.
Follow steps below to attach grass catcher:
a.
Lift rear discharge door.
b.
Place grass catcher into the slots in the handle brackets as shown in
Figure 8. Let go of discharge door so that it rests on the grass catcher.
To remove grass catcher, lift rear discharge door on the mower. Lift grass catcher up
and off the slots in the handle brackets. Release rear discharge door to allow it to
close rear opening of mower.
Adjustments
Cutting Height
There is a cutting height adjustment lever located above the front and rear right
wheel.
1.
Pull the height adjustment lever outward towards wheel (unit will tend to
fall when lever is moved outward). See Figure 9.
2.
Move lever to desired position for a change in cutting height. See Figure 9.
3.
Release lever towards deck.
IMPORTANT: All wheels must be placed in the same position. For rough or uneven
lawns, move each height adjustment lever to a higher position. This will prevent you
from cutting the grass too close to the ground.
b
a
Figure 7
ASSEMBLY
Lower
1
3
10
b
b
Figure 8
2
Higher
Higher
1
3
Figure 9
a
2
Lower
Publicidad
