Create UPWIND SAIL Manual Del Usuario página 12

Installing the fan blades
Blade
screws
1
Align the holes on the blade holder with the holes on the blades and the motor body and
screw them in place (1), but don't tighten them until they are all placed and screwed in.
Once the blades are tighten on the blade holder, screw the structure to the motor housing
(2) until it is secured as in picture (3).
LED light panel and lamp shade assembly
Unscrew a set screw. Attach the LED pan up to the bottom of the fan by inserting the other two
set screw heads into the key hole slots. Rotate it to place, then secure the previous set screw by
aligning the screw hole and the hole at the bottom of the fan, tighten the rest two set screws to
secure the LED pan.
NOTE: While installing or removing the LED pan, please keep the insulation pads intact. Turning
the set screws over-tightly or fastened will damage the insulation pads.
Restore the cover and the lamp shade back to the LED pan, and secure them with decorative
clips and bolt nuts
E NGL I SH
12
2
CEILING FAN WITH LED LIGHT
Lamp panel
Lamp panel screw
3
Single-pin
plug
LED panel