Publicidad
Idiomas disponibles
Idiomas disponibles
Adding or taking out laundry
Press the Start / Pause button to switch the
machine to pause mode. The programme
follow-up light of the relevant step during which
the machine was switched into the pause
mode will flash.
Wait until the Loading Door can be opened.
Open the Loading Door and add or take out
the laundry. Close the Loading Door. Make
changes in auxiliary functions, temperature
and speed settings if necessary. Press Start /
Pause button to start the machine.
Canceling the programme
To cancel the programme, turn the Programme
Selection knob to select another programme.
Previous programme will be canceled. End /
Cancel light will flash continuously to notify that
the programme has been canceled.
Pump function is activated for 1-2 minutes
regardless of the programme step, and
whether there is water in the machine or not.
After this period, your machine will be ready to
start with the first step of the new programme.
Depending on the step where the
C
programme was canceled in, you may
have to put detergent and softener again
for the programme you have selected
anew.
End of programme
"End" appears on the display at the end of the
programme. Wait until the loading door light
illuminates steadily. Press On / Off button to
switch off the machine. Take out your laundry
and close the loading door. Your machine is
ready for the next washing cycle.
5 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if cleaned
at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every 4-5 washing cycles) as shown below
in order to prevent accumulation of powder
detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you
until the compartment is removed from the
machine.
If more than normal amount of water and
C
softener mixture starts to gather in the
softener compartment, the siphon must
be cleaned.
Wash the detergent drawer and the siphon
with plenty of lukewarm water in a washbasin.
Wear protective gloves or use an appropriate
brush to avoid touching of the residues in the
drawer with your skin when cleaning. Insert the
drawer back into its place after cleaning and
make sure that it is seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreign substances and dirt in the water to
enter the washing machine. Filters should be
cleaned as they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush. If the filters are too dirty, take them
out by means of pliers and clean them. Take
out the filters on the flat ends of the water
intake hoses together with the gaskets and
32
EN
Publicidad
