Power Supply; Setting Into Operation; Adjusting The Transmission Group And The Transmission Channel - Monacor International JTS MH-8800G Manual De Instrucciones

4 Power Supply

G
Only insert batteries of the same type and always
replace all batteries.
G
If the microphone is not used for a longer period
(e. g. more than a week), remove the batteries.
Thus, the microphone will not be damaged in case
of battery leakage.
1) Unscrew the cap (7) for the battery compartment.
2) Insert two 1.5 V batteries of size AA (R6) with the
positive and negative connections as indicated on
the holder.
3) Place the battery compartment cap straight against
the thread of the microphone body and screw it on.

5 Setting into Operation

1) Before switching on the microphone, set the re -
ceiver to an interference-free transmission channel,
see instruction manual of the receiver.
2) Then switch on the microphone: Set the POWER
switch (9) at the lower end of the microphone to
position POWER. If required, slide the safety cap
(10) downwards beforehand. The display will indi-
cate the transmission group adjusted with the cor-
responding transmission channel (3) and a battery
symbol (2) showing the current charging status of
the batteries in several steps:
fully charged
3) The keys (4 – 6) which are slightly recessed can
easily be actuated by means of the tip of your
thumb without any further aid.
4) Set the microphone to the same transmission
group and the same transmission channel adjusted
on the receiver → chapter 5.1.
5) Speak/sing into the microphone. The mute switch
(11) must be in the position OFF, otherwise no
audio signal will be transmitted. The volume level of
the microphone can be readjusted by modification
of the sensitivity → chapter 5.2.
6) The microphone can be locked to prevent acciden-
tal modification of the adjustments or switching off
→ chapter 5.3.
7) For short interruptions, the signal transmission can
be muted → chapter 5.4.
8) The identification ring (8) can also be exchanged
against one of the coloured rings supplied. This
allows colour coding of several systems with dif -
ferent radio frequencies.
9) To switch off the microphone after operation, set the
POWER switch (9) to OFF.
8
exhausted
5.1 Adjusting the transmission group and the
transmission channel
1) Keep the key SET (6) pressed for 2 s until the dis-
play shortly indicates
tion , , or flashes.
Note: To exit the adjusting mode without making an
adjustment, press the key SET so many times
until the display shows
will then return to normal operation.
2) Use the cursor keys to adjust the transmission
group: With the key
in descending order, with the key
order. The corresponding channels and transmis-
sion frequencies can be found in the table fig. 4.
Note: If other wireless transmission systems are
operated at the same time, the radio frequencies
of the individual systems should be carefully
matched to each other to prevent interference.
Examples for frequencies for simultaneous op -
eration of several systems can be found in the
Internet on www.jts-germany.de under "Informa-
tionen/Intermodulationsfreies Frequenzsetup".
3) Press the key SET again to recall the channel ad -
justing mode. On the display, the channel indication
1 – 16 starts flashing.
4) Use the cursor keys to adjust the transmission
channel: With the key
scanned in descending order; with the key
will be scanned in ascending order.
5) To memorize the adjustment, press the key SET.
The display will shortly show
mode will be exited, and the microphone will go to
normal operation.
Group
A
Channel
1 790.875
2 792.625
3 794.250
4 795.625
5 797.125
6 798.875
7 801.125
8 802.250
9 803.625
10 805.250
11 805.750
12 808.625
13 809.125
14 810.000
15 813.250
16 813.750
Fig. 4 Transmission frequencies in MHz of the groups
and channels
. Then the group indica-
. The microphone
(4) the groups will be scanned
(5) in ascending
, the channels will be
, the adjusting
B C
790.750 791.125 790.625
791.375 791.750 791.125
793.125 792.625 791.875
794.000 793.750 793.625
795.250 794.500 795.875
796.250 796.125 797.125
796.875 796.875 797.875
798.000 798.250 799.125
798.875 799.000 800.875
800.250 800.875 801.375
803.250 804.500 802.875
804.000 805.875 803.375
805.625 806.625 804.125
806.750 807.750 806.250
808.250 808.375 807.625
813.750 813.750 813.625
, they
D