Publicidad
Idiomas disponibles
Idiomas disponibles
Gun operation
Battery () is intentionally shipped with a
low charge. Charge the Battery prior to use.
Refer to the Battery charger operation,
page for details.
NOTE*
Grease gun is equipped with software to
protect motor. Software will cut power
to motor and LCD will light with solid red
backlight when blocked bearing, line, or
grease fitting causes gun to stall.
Release trigger immediately if this
situation occurs.
For maximum motor life, avoid
operating at stall.
Failure to comply may result in
property damage.
Speed selection
The gun is equipped with a two speed
electronic transmission to provide a high and
low flow rate, refer to Specifications for
performance at each speed. The gun is in
high speed when "" is shown on the slide
switch (), see figure for illustration.
Maximum pressure can be achieved in both
high () and low speed () (→ fig. ).
NOTE*
Grease gun will automatically switch
from low speed to high speed
around psi (241 bar) to obtain a
higher pressure.
*
Indicates change.
Cordless grease gun series (includes battery charger)
LCD functions
The liquid crystal display (LCD) () features
an electronic grease meter, grease level
gauge, and battery level indicator. To turn
the LCD ON, tap the reset button () one
time (→ fig. ).
To enter reset mode, press and hold the
reset button. After seconds the digits of the
grease meter begin to flash, unit of measure
(oz/g).
Releasing the reset button when grease
meter digits is flashing will reset the meter to
zero, releasing the button while the grease
cylinder level segments are flashing will
restore the gauge to full, and releasing the
button while the unit of measure is flashing
will change unit of measure.
Stall indication
During stall condition (in the case of a
clogged fitting or line) the gun will stop
pumping grease and the LCD display will be
illuminated with Red backlight. If this condi-
tion occurs, release trigger immediately.
Inspect, clean, and/or fix the grease passage
before trying to dispense grease into the
system.
46
49
50
Loss of prime indication
Loss of prime occurs when there is an air
pocket in the grease or when the grease
cylinder is empty. When this occurs the LCD
screen will flash Red to indicate that the gun
is not pumping grease. During loss of prime
the grease meter does not count empty
piston strokes.
Fig.
Publicidad
