USE OF THE BATTERY AND CHARGER
When the charger is plugged into an electrical outlet, you can use the LED light to
guide you to the battery's state of charge:
- The red LED light indicates that the
Luz LED del cargador
battery is low, so it will start charging.
- The green LED light will turn on when the
battery is fully charged.
Important!*
The correct order for connecting the battery
to the mains is always to connect the charger
to the battery first and then to the mains,
otherwise a short-circuit may occur and
render components of the E-BIKE unusable.
Before charging, you must switch off your
bike completely (including the display).
Always connect the charger to your bicycle before connecting it to the power supply,
otherwise you may damage the battery charger and render the battery unusable.
Use only the original charger and lithium battery supplied with the bicycle. Other
types of chargers or batteries may cause serious injury or irreversible damage to
the bicycle.
If the charger is damaged or no longer charges, contact the authorised dealer from
whom you purchased the bicycle. Never open or tamper with the watertight battery
compartment, as this may cause serious injury and may also void the warranty.
Use the original battery only indoors or outdoors in dry conditions and never in
damp, wet or rainy environments or in high humidity situations. Do not use the
battery in very hot environments as this may cause the battery to stop working or
even cause serious injury or damage to the bicycle.
31
MEGAMO USER'S MANUAL
| RIDON 630