Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
1.
Shut off the water at the supply valve under the sink or at the
main water supply. Disconnect the supply lines. Remove the
existing faucet from the sink.
Clean and dry the surface area where the new faucet will
be mounted.
2.
Ensure the gasket (2.1) is in place on the bottom of the faucet body
(A). Apply a thin bead of silicone sealant to the underside of the
gasket (2.1).
Insert the shanks (2.2) on the faucet body (A) through the holes in
the sink. From underneath the sink, thread the mounting nuts (AA)
onto the shanks (2.2) on the faucet body (A). Check the position of
the faucet and hand tighten until the faucet is securely mounted.
NOTE: It is helpful to have a second person hold the faucet in
place while tightening the mounting nuts (AA).
Hardware Used
Mounting nut
AA
3.
Attach one end of each of the water supply lines onto the shanks
(3.1) on the faucet body (A), with hot water on the left and cold
water on the right. Use 1/2 in. IPS faucet connections (3.2) or
supply line coupling nuts (3.3) with 3/8 in. OD ball-nose risers (3.4).
NOTE: Do not reuse existing supply lines. When installing new
water supply lines, please refer to the supply line manufacturer's
installation instructions. Tighten the supply line connections using
an adjustable or basin wrench. Do not overtighten.
Attach each of the remaining ends of the water supply lines to the hot
and cold shut-off valves and tighten with a wrench. Do not overtighten.
4.
Remove the old pop-up drain assembly. Clean all sink surfaces
to remove old putty and dirt before installing the new drain
assembly. Remove the flange and upper threaded portion (4.1)
of the pop-up drain assembly from the bottom gasket (4.2),
mounting nut (4.3) and the lower portion of the pop-up drain
assembly (B).
x 2
4
1
2
AA
3
3.1
3.2
4
A
2.1
2.2
3.4
3.3
Publicidad
