Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS (continued)
5.
Insert the flange and upper portion of the pop-up drain assembly
(5.1) into the sink hole (5.2).
6.
From underneath the sink, attach the rubber gasket (6.1) and
mounting nut (6.2) onto the upper portion of the pop-up drain
assembly (6.3). Then twist the bottom of the pop-up drain
assembly (B) onto the upper portion of the pop-up drain assembly
(6.3) and hand tighten. Do not overtighten.
7.
After installation is complete, remove the aerator (7.1) from the
spout (7.2) on the faucet body (A).Turn on the water supply.
Check for leaks at all waterway connections. If leaks occur,
tighten the nuts on the water connection that is leaking. Fill the
sink with water to check the drain for leaks. If water is leaking
from the drain, tighten the mounting nut on the pop-up drain
assembly (B).
After the pop-up drain has been checked for leaks, empty the
sink. Run hot and cold water uninterrupted for at least one minute
to flush away any debris that could cause damage to the internal
parts.Turn off the water and reattach the aerator (7.1) onto the
spout (7.2) of the faucet body (A).
REPLACING LED AERATOR WITH NON-LIGHTED AERATOR
1. Hold the end of
the faucet spout
(1.1) and turn
the LED aerator
(1.2) clockwise
to remove it from
the faucet
body (A).
1
A
1.1
1.2
2. Thread the non-
lighted aerator (C)
onto the end of the
spout (2.1) on the
faucet body (A) in
a counterclockwise
direction. Hand
tighten, but do not
overtighten.
5
5
5.1
5.2
6
7
7.2
7.1
2
2.1
C
A
A
Publicidad
