Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Hook the claws of the chip receiver to the groove
on the shear blades.
Fig.20
► 1 . Claw 2. Groove
3.
Press the levers on the chip receiver, and then hook the
claws on the other side to the groove on the shear blades.
Make sure that all the claws are hocked in the groove of
the guide bar firmly.
1
Fig.21
► 1 . Lever 2. Claw
To remove the chip receiver, press the levers to release
the claws.
Fig.22
► 1 . Lever
NOTICE:
by an excessive force with its hooks locked to the
shear blades.
1
OPERATION
2
WARNING:
blades.
CAUTION:
hot weather as much as practicable. When operat-
ing the tool, be careful of your physical condition.
CAUTION:
contact a metal fence or other hard objects while
trimming. The shear blades may break and cause
2
an injury.
CAUTION:
blades to contact the ground. The tool may recoil
and cause an injury.
CAUTION:
mer, particularly from a ladder, is extremely
dangerous. Do not work while standing on anything
wobbly or infirm.
NOTICE:
than 10 mm (3/8") in diameter with the tool. Cut
2
branches to 10 cm (4") lower than the cutting height
using branch cutters before using the tool.
1
Fig.23
► ( 1) Cutting height (2) 10 cm (4")
NOTICE:
hard objects. Doing so may damage the tool.
NOTICE:
using the shear blades. The shear blades may
become tangled in the grass or weeds.
1
12 ENGLISH
Never try to remove the chip receiver
Keep hands away from shear
Avoid operating the tool in very
Be careful not to accidentally
Be careful not to allow the shear
Overreaching with a hedge trim-
Do not attempt to cut branches thicker
Do not cut down dead trees or similar
Do not trim the grass or weeds while
(1)
(2)
Publicidad
