Publicidad
Idiomas disponibles
Idiomas disponibles
Re� t all the removed parts.
Adjust the cleaver blade (5) as described
below.
Switch the saw on and allow it to run freely
for one minute to check that it is functioning
correctly.
Adjusting the cleaver blade
See � gures 3, 5, 6 and 7.
There must be at least 3-5 mm between the
saw blade and the cleaver blade.
Set the saw blade vertical and lower it as
much as possible by turning the handwheel
(8).
Remove the blade guard (2).
Loosen the recessed screw (17) and lift up
the bench inlay (6).
Loosen the assembly screw (19).
Raise or lower the cleaver blade (5)
If the bench circular saw is to be adjusted to
the maximum sawing depth, raise the cleaver
blade until the distance from the saw bench
(1) and the top of the cleaver blade is around
10 cm.
Retighten the assembly screw (19) and
replace the bench inlay and blade guard.
Cleaning and maintenance
Remove sawdust and dirt using a vacuum
cleaner, or a brush.
Check that the motor ventilation slots are not
blocked.
Wipe the exterior parts of the saw with
a dampened cloth. Never use strong or
corrosive detergents.
Lubricate all moving parts with a light
lubricating oil.
If the carbon brushes are worn down, they
must both be replaced.
Service centre
Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
•
Complaints
•
Replacement parts
•
Returns
•
Guarantee issues
•
www.schou.com
GB
57
Publicidad
