Maintenance; General Maintenance - Echo SSA-58V Manual Del Operador

MAINTENANCE

WARNING
Before inspecting, cleaning, or servicing the machine,
shut off motor, wait for all moving parts to stop, and
remove battery. Failure to follow these instructions can
result in serious personal injury or property damage.
WARNING
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
NOTICE
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal
injury.
8
The line cut-off blade on the debris shield is sharp. Avoid
contact with the blade. Failure to avoid contact can
result in serious personal injury.
String Head Replacement
See Figure 7.
The string head should be replaced whenever damage is
visible or if the wear indicators on the face are worn smooth.
If replacing line only, refer to Line Replacement later in this
manual.
 Stop the unit and remove the battery pack.
 Place the gear head locking tool or screwdriver through
the slot in the debris shield and gear head.
 Rotate the string head clockwise until it can be removed
from the output shaft.
 Install the new string head and rotate counterclockwise
to secure.
Line Replacement
See Figures 8 - 11.
Use 0.080 in. diameter round, 0.080 in. twisted, 0.095 in.
twisted or 0.095 in. octagonal trimmer line only.
 Stop the unit and remove the battery pack.
 Rotate the string head as necessary to align the eyelets
in the string head housing with the arrows on the base
of the string head.
 Cut one piece of trimmer line 12 ft. long. Insert the line
into the eyelet on the string trimmer housing. Push until
the end of the line comes out the other side of the string
head. Pull the line from the other side until equal amounts
of line appear on both sides.
 While holding the string head body, rotate the string head
base counter-clockwise to wind the line on the spool until
approximately 6 in. of line is showing on each side.
 Push down on the string head face while pulling on line(s)
to manually advance the line and to check for proper as-
sembly of the string head.
English
WARNING