Domo DO7105S Manual De Instrucciones página 46

DO7105S
Button for releasing watertank
Grasp the water reservoir by its handle and press and hold the button. You are now
able to remove the water reservoir from the generator.
Filling cap
Open the filling cap and use the opening to fill the water tank.
Temperature indicator
When the iron is heating up, the temperature indicator will be lit up. When the set
temperature has been reached, the light indicator will go out again. During ironing the
indicator will alternately light up and go out again, as the iron is being kept at the right
temperature.
Steam release button
Press the steam button on the inside of the iron's handle to release a constant stream
from the sole plate. When you release the button, you will iron dry, without steam.
Cord clamp
After use you can easily store the cord and steam hose by using the cord clamp. Pull
out the clamp, lead the steam hose and the cord around the steam generator and push
in the clamp to lock the cord and steam hose.
Temperature dial
Set the right temperature for the right fabric with the temperature dial.
For synthetic fabrics/silk:
For wool:
For cotton:
For linnen:
BEFORE THE FIRST USE
1. Remove any stickers and protective film from the machine and the sole plate.
2. Heat up the iron until the maximum temperature and iron on a damp cloth during
a couple of minutes to remove any possible residues from the soleplate. Iron
according to the instructions in the section «Steam ironing».
Caution:
• During the first use it is normal that a specific odeur escapes from the appliance.
This odeur will disappear after a while.
• Some particles may come out of the soleplate during the first use. This is normal.
The particles are harmless and will disappear after a while.
• When you turn on the machine, the steam generator may make a pumping noise.
MAX
46