Beko 01M-8851153200-3820-13 Manual Del Usuario página 14

4 Cleaning and maintenance
Before carrying out any maintenance operations
on the appliance, remove the plug from the wall
outlet. The hood should be cleaned with mild
cleaning agents, do not use abrasives. Regular
maintenance ntly improves the performance and
durability of the hood. The hood should be cleaned
at least once a month or every 35 hours of hood
operation. To clean hood DO NOT USE ALCOHOL-
BASED AGENTS. Satin items (inox) should be
cleaned with special preparations for that purpose.
Failure to comply with the
provisions relating to cleaning of
the device and replacement of
A
filters may cause fire risks. It is
therefore recommended to comply
with the guidelines given herein.
The manufacturer is not lia- ble for
any damage to the engine or fires
caused by improper use.
4.1 Grease filter
The hood is equipped with an aluminum filter,
which retains the fat particles from cooking. The
ter can be removed by moving the locks in the
direction of the arrows (Fig. 6). The ter should be
washed by hand by immersing for 15 minutes in
water with dishwashing liquid at a temperature of
40-50°C. After 15 minutes, you can proceed with
washing and then rinsing. The ter must be dry
before being placed in the hood. The ter can also
be washed in a dishwasher. During the washing
procedure, the ter may discolor, however it does
not a ect its tering properties. If the ter is not
cleaned regularly, it reduces the performance of
the hood and could cause the risk of re. The ter
should be cleaned at least after each 35 hours of
hood operation.
4.2 Carbon filter
The hood can be ted with an active carbon ter.
The carbon filter is applied only in case the hood is
not connected to the vent pipe.
14 / EN
The filter should be placed on the turbine casing,
as shown in drawing (Fig. 6 ). The active carbon
filter should be replaced every 6 months.
A
The carbon filter shall not be washed
nor regenerated.
Fig.6 Replacing the carbon filter
Hood / User Manual