Faults - What To Do - Gaggenau VR 414 Manual De Instrucciones

en-us
Faults – What to Do?
Faults – What to Do?
9
WARNING
F a u l t s – W h a t t o D o ?
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only
be carried out by an authorized servicer. If the
appliance is not functioning properly, unplug the
power cord or switch off the fuse in the fuse box.
Contact Customer Support.
Disruption
The appliance does not work
The appliance is not working and the
illuminated ring behind the control knob
is flashing orange and white alternately
The appliance does not heat up when it
is switched on.
All the illuminated rings behind the con-
trol knobs light up white for 10 seconds
after it is switched on. The illuminated
ring around the active control knob then
lights up orange.
The appliance does not heat up when it
is switched on.
The illuminated ring behind the control
knob is flashing yellow and magenta
alternately.
The appliance switches off when it is in
operation.
The illuminated ring behind the control
knob flashes orange and white alter-
nately.
The appliance switches off when it is in
operation.
The illuminated ring behind the control
knob flashes orange and white alter-
nately.
--------
18
Faults often have simple explanations. Please read the
notes in the table before calling customer service.
Possible cause
The plug is not plugged in
Faulty fuse
Power failure
Power failure
Demo mode is activated
Electronics fault
Safety switch off:
The controls on the appliance
have not been used for a long
time.
Power failure in the house-
hold:
Following a power failure, the
appliance remains switched
off for safety reasons.
Solution
Connect the appliance to the mains
Check in the fuse box to make sure that the
fuse for the appliance is in working order
Check whether other kitchen appliances are
working
Check whether other kitchen appliances are
working
Deactivate demo mode.~ "Demo Mode"
on page 19
Turn all control knobs to 0 and disconnect the
appliance from the power supply for one min-
ute (switch off the circuit breaker or pull out
the plug).
Reconnect the appliance. The illuminated
rings around the control knobs light up green
for a few seconds and then turn yellow. Wait
until the illuminated rings switch off. Then
turn any of the control knobs to any of the grill
settings and then back to 0.
Switch on the appliance. If the illuminated
ring starts flashing yellow and magenta alter-
nately again, call the after-sales service.
Turn all control knobs to 0, and then switch
them back on if you wish to continue using the
appliance.
Turn all control knobs to 0, and then switch
them back on if you wish to continue using the
appliance.