Num'axes SL1008 Manual De Instrucciones página 64

Aims Your Camera
Your camera has a built-in laser beam to indicate the PIR Sensor
detection coverage area and the capture area. Please follow the
instructions below to test that area:
•
After mounting the camera on a pillar or tree using the
supplied mounting strap, open the cover and then slide
the switch from the OFF position to the SET position.
•
Press and hold the [M] button for
3 seconds, the status display will show
"tESt", and the laser beam will start
blinking from the front housing.
•
The laser beam is pointing to the
capture/detection area center.
•
Adjust the camera position as needed and repeat testing
until the desired coverage area is achieved.
•
The laser beam will turn off automatically after 30
seconds, or you can turn it off by pressing and holding the
[M] button for 3 seconds.
•
When you have completed testing, slide the switch back
to the OFF position from SET.
Warning: Do not point the laser beam to the eyes.
SL1008 - Indice A 64/200