Shenzhen Urion Technology UFR-106 Manual De Usuario página 43

●
Before aiming at the target, please remove water, dust or dirt.
●
When an infrared thermometer is aimed at the forehead, please clean the scanning area and remove hair
or sweat to ensure the probe is clean.
●
When measuring human body temperature, the center of forehead should be aligned at a distance of
3-5 cm to avoid contact between the sensor head and human body.
8.8 Object Temperature Measurement
a. Press the "measure" button to start the device. At this time, the LED displays a yellow backlight and
displays all segments.
b.
Press mode key to make infrared thermometer enter object temperature measurement mode. An icon
indicating that the device enters the object mode.
c.
Aim the sensing probe at the object to be measured at a distance of 3-5 cm, then press the measure
button to start measuring the temperature.
d. When you hear a short beep, the object temperature has been measured and the measurement is
complete and the measurement results can be read.
e.
Three measurements are recommended. If the three measurements are di erent, select the highest
temperature value.
8.9 View and clear Memory Values
A. Read Memory Values
The product will automatilcally record the data obtained in each test. Up to 32 measurement data can be
recorded. You can view these data by following the steps below:
a.
In the standby state, press the "+" button, the device can display the last measured temperature.
b. Press the "+" button again, the last data will be displayed, and so on, and you can view the stored
measurement data.
c. If without pressing any key, it will exit this mode within 10 seconds and automatically shut down.
The infrared thermometer can automatically save the most recent 32 measurement values.
If the memory times are full, the earliest measurement result will be deleted.
7