Publicidad
Idiomas disponibles
Idiomas disponibles
10. Troubleshooting of Abnormal Measurement Result
Display identification
* If the error message cannot be eliminated, please contact the manufacturer.
11. Cleaning, Storage and Disposal
Cleaning
●
Clean the thermometer according to the requirements of this manual after each use.
●
Use a soft, dry cloth to wipe and clean the device. Be careful not to wipe with volatile oil or thinner.
●
Do not allow liquids to enter the product. The recommended cleaning frequency is once a week.
You can use the absorbent cotton dipped in 70% alcohol to gently wipe the case and sensor head
●
(except the panel and nameplate). The recommended disinfection cycle is once a month.
Do not clean the device with corrosive detergent.
●
Storage
●
Do not store or only use the device in damp, high temperature, falling, dust, sun and other environments.
●
Do not disassemble or modify this medical infrared thermometer without permission. If you replace the
original parts with parts not provided by the manufacturer, it may cause measurement errors.
●
Do not use in the environment with electromagnetic wave interference (such as mobile phones or
microwave ovens, amateur radio, AM and FM radio broadcasts and TV broadcasts).
Significance
Excessive measurement
temperature
Measuring temperature too
low
Battery power low prompt
System failure
Possible causes and methods to resolve
Temperature mode: the measured target
temperature is higher than 43°C.
Temperature mode: the measured target
temperature is below 32°C.
Battery power is insufficient and "Lo" is displayed
on the screen.
Please replace the battery immediately.
Return to the seller, or contact with the local
distributors to consult handling method.
9
Publicidad
