STEINEL L 620 CAM SC Manual Del Usuario página 18

Changing the memory card
• Undo retaining screw and remove
cover ( Fig. 6.1 )
• Changing memory card ( Fig. 6.2 )
• Fit cover and tighten retaining screw
( Fig. 6.4 )
Restoring factory settings
• Press the reset button for approx.
7 seconds ( Fig. 6.3 )
Note:
Pressing the reset button with the key
will return the camera light to factory
settings.
Once the light has been reset, an acous-
tic signal will sound every 4 seconds.
• Fit cover and tighten retaining screw
( Fig. 6.4 )
7. Maintenance and care
The camera light requires no mainte-
nance.
Weather conditions may affect the way
the camera light functions. Strong gusts
of wind, snow, rain or hail may cause
the light to come ON when it is not
wanted because the sensor is unable to
distinguish sudden changes of tempera-
ture from sources of heat. Detector lens
and camera lens may be cleaned with a
damp cloth if they get dirty ( do not use
cleaning agents ).
Important note: the control gear cannot
be replaced.
8. Disposal
Electrical and electronic equipment,
accessories and packaging must be re-
cycled in an environmentally compatible
manner.
Do not dispose of electrical
and electronic equipment as
domestic waste.
EU countries only:
Under the current European Directive on
Waste Electrical and Electronic Equip-
ment and its implementation in national
law, electrical and electronic equipment
no longer suitable for use must be
collected separately and recycled in an
environmentally compatible manner.
9. Declaration of
Conformity
Hereby, STEINEL Vertrieb GmbH
declares that the radio equipment type
L 620 CAM SC is in compliance with
Directive 2014/53/EU. The full text of the
EU declaration of conformity is available
at the following internet address:
www.steinel.de
18