Thunderbolt Port Set For Display; 3G/4G Module; Usim Card Insertion - Clevo P750DM Manual Del Usuario

Thunderbolt Port Set for Display

The display configuration for the Thunderbolt port and
Mini DisplayPorts can be set up in the BIOS (Advanced
menu > Advanced Chipset Control > DDI Control). If
you want to use the Thunderbolt Port for connecting dis-
play devices then set the DDI Control to "DDI to TBT".
Restart your notebook computer and press F2 to enter the
BIOS.
When the Thunderbolt port is set to be used for display on-
ly, then Mini DisplayPort 1 (
15 in Figure 7 on page 13) will be disabled.
Thunderbolt™ Devices
When plugging a device into a Thunderbolt port alllow 30
seconds for the system to scan and recognize the connect-
ed device.
Ejecting Thunderbolt Devices
In order to prevent system problems make sure you do not
simply pull the cable out from the Thunderbolt port. The
hardware must be ejected safely:
1. Go to the notification area of the taskbar and click on the
Safely Remove Hardware and Eject Media icon.
2. Click on Eject "Thunderbolt Device Name".
3. When you see the "Safe to Remove Hardware" mes-
sage you can remove the cable.
in Figure 6 on page
17


3G/4G Module

(Optional for Models A & B Only)
If you have included an optional 3G/4G module in your
purchase option, follow the instructions below to install
the USIM card (which will be provided by your service
provider).

USIM Card Insertion

1. Turn off the computer, and turn it over and remove the battery
1
.
12/
2. Insert the USIM card as illustrated below until it clicks into
position, and replace the battery.
1
USIM Card Orientation
Note that the USIM card's readable side (with the gold-
colored contacts) should face upwards as illustrated.
Figure 9 - Remove the battery and Insert the USIM Card

15