Uline H-1130 Manual De Instrucciones página 2

MOUNTING WITH SCREWS AND ANCHORS
(NOT INCLUDED)
For use on most wall surfaces, use screws and anchors or
other appropriate hardware based on surface type.
1. Remove lid with key. Push latch out and detach
dispenser from back plate. (See Figures 3-4)
Figure 3
REFILLING
CAUTION! Use foam soap only for foaming
soap dispensers and liquid soap only for liquid
soap dispensers. Foam soap dispensers handle
foam soaps from 0-14 centipoise (cps).
WARNING! Soap containing any type of
scrubbers will cause the dispenser to leak
and eventually fail.
1. Remove lid. Push key
into slot at back right
side of lid.
(See Figure 6)
2. Fill dispenser with
appropriate soap and
replace lid.
3. Prime the dispenser.
Push button 6-10 times.
PAGE 2 OF 6
INSTALLATION CONTINUED
Figure 4
Latch
OPERATION
Figure 6
1-800-295-5510
2. Using the back plate as a template, mark hole
locations on wall. (See Figure 5)
Figure 5
3. Drill 3/16" diameter holes for anchors and screws
or other hardware. Attach back plate to wall with
screws.
4. Slide dispenser onto back plate and replace lid.
MAINTENANCE
Clean and maintain the dispenser on a regular,
scheduled basis.
CAUTION! Never use abrasive cleaners when
cleaning soap dispensers.
• Flush tank and pump mechanism with warm water
to remove residue and contaminate. Refill with new
soap and replace lid.
• Clean all touch-points on dispenser with disinfectant.
• Thoroughly clean all internal and external parts.
uline.com
0523 IH-1130