REF: 751B278856
777D14479
777I22453
777I23092
777S30018
DANGER
ROTATING BLADES CAUSE
SERIOUS INJURY OR DEATH
• DO NOT MOW WHEN CHILDREN OR OTHERS ARE
AROUND
• NEVER CARRY CHILDREN EVEN WITH BLADE(S) OFF.
• LOOK DOWN AND BEHIND BEFORE AND WHILE
BACKING.
• MOWING IN REVERSE IS NOT RECOMMENDED.
TO AVOID SERIOUS INJURY OR DEATH
• GO UP AND DOWN SLOPES, NOT ACROSS.
• AVOID SUDDEN TURNS.
• DO NOT OPERATE THE UNIT WHERE IT COULD SLIP OR TIP .
• IF MACHINE STOPS GOING UPHILL, STOP BLADE(S)
AND BACK DOWNHILL SLOWLY .
• KEEP SAFETY DEVICES (GUARDS, SHIELDS, AND
SWITCHES, ETC.) IN PLACE AND WORKING.
• REMOVE OBJECTS THAT COULD BE THROWN BY THE BLADE(S).
• KNOW LOCATION AND FUNCTION OF ALL CONTROLS.
• BE SURE BLADE(S) AND ENGINE ARE STOPPED BEFORE
PLACING HANDS OR FEET NEAR BLADE(S).
• BEFORE LEAVING OPERATOR'S POSITION, DISENGAGE
BLADE(S), ENGAGE PARKING BRAKE, SHUT OFF AND
REMOVE KEY .
READ OPERATOR'S MANUAL
Operation Of This Equipment May Create Sparks That Can Start
Fires Around Dry Vegetation. A Spark Arrestor May Be Required.
The Operator Should Contact Local Fire Agencies For Laws Or
Regulations To Fire Prevention Requirements.
777x44381
Center below Seat
(qTY 2) 777D14489
777S30503
DANGER
KEEP HANDS AND FEET AWAY .
DO NOT OPERATE MOWER
UNLESS CHUTE DEFLECTOR
OR ENTIRE GRASS CATCHER IS
IN ITS PROPER PLACE.
S30503
ASSEMBLE CHUTE DEFLECTOR TO THIS UNIT BEFORE OPERATING.
Labels
777S32491
TO START
1. DISENGAGE BLADES/PTO, (POWER TAKE OFF)
2. ENGAGE THE TRACTOR'S PARKING BRAKE.
3. ACTIVATE THE CHOKE CONTROL.
4. TURN KEY TO START ENGINE. AFTER START RELEASE KEY & DEACTIVATE CHOKE
BY PLACING THROTTLE TO FAST "RABBIT" POSITION.
OPERATING MODES
NORMAL MOWING
YOU MUST DISENGAGE BLADES/PTO, (POWER TAKE OFF)
BEFORE TRAVELING IN REVERSE.
REVERSE
CAUTION MODE
1. TURN KEY TO REVERSE CAUTION MODE POSITION.
2. DEPRESS REVERSE PUSH BUTTON. (RED INDICATOR LIGHT "ON")
WHEN RED LIGHT IS "ON" MACHINE CAN BE OPERATED
IN REVERSE WITH MOWER BLADES ENGAGED.
IMPORTANT: MOWING IN REVERSE IS NOT RECOMMENDED.
3. AFTER RESUMING FORWARD OPERATION, RETURN
KEY TO "NORMAL MOWING" POSITION.
NOTE: IN BOTH MODES, WHEN OPERATOR LEAVES SEA T ,
ENGINE WILL STOP UNLESS PARKING BRAKE IS SET AND
BLADES ARE DISENGAGED.
BRAKE / CLUTCH
P
PEDAL
Brake / Clutch Pedal On Drivers Left Side Of Rider
IF UNIT STALLS WITH SPEED CONTROL IN HIGH SPEED, OR IF UNIT
WILL NOT OPERATE WITH SPEED CONTROL LEVER IN A LOW SPEED
POSITION, PROCEED AS FOLLOWS:
1. PLACE SHIFT LEVER IN NEUTRAL.
5. DEPRESS CLUTCH-BRAKE PEDAL.
2. RESTART ENGINE.
6. PLACE SPEED CONTROL LEVER
3. PLACE SPEED CONTROL LEVER
IN DESIRED POSITION.
IN HIGH SPEED POSITION.
7. PLACE SHIFT LEVER IN EITHER
4. RELEASE CLUTCH-BRAKE PEDAL
FORWARD OR REVERSE AND FOLLOW
FULL Y .
NORMAL OPERATING PROCEDURES.
For A List Of Optional Attachments,
Please Refer To Your Operators Manual.
®
19.5 HP
ENGINE
777I22454
29
777X43688
DO NOT
USE E85 OR FUEL
CONTAINING MORE
THAN 10% ETHANOL
ReF. 777D14476 (qTY 3)
777D14483
777D14482
777I22455
Place Lever Fully To Run
Position To Operate Unit.
PARK BRAKE OPERATION:
1st.
2nd.
Press
Move
Brake
Lever
Pedal
To Park
I23366 AC
7
6
5
4
3
2
1
PARK
BRAKE
777I22773
NOTICE
STEERING WHEEL
FORMAT #
MOUNTING HARDWARE
UNDER CAP, BEFORE
COLORS
OPERATION SECURE
BLACK / MTD RED
STEERING WHEEL TO
SHAFT ACCORDING
TO MANUAL
777I22456
CHOKE
FAST
SLOW