Wagan Tech 7506 Manual De Usuario página 9

Brief Recap of Sequences for Connection and Disconnection
ORDER OF CONNECTION
1. Connect positive (red)
clamp to positive battery
ORDER OF DISCONNECTION
1
1.
READ THE REMAINDER OF THE INSTRUCTIONS BEFORE USING THE IONBOOST!
Jumpstart Procedure
1. Make sure iOnBoost is fully charged.
2. Turn off the vehicle ignition and all accessories (radios, lights, air conditioners), and disconnect
electronic devices.
3. Set the emergency brake and put vehicles with automatic transmission in park position.
4. Determine the polarity of the vehicle's battery terminals. The positive (POS, P, +) battery
terminal usually is red and larger in diameter than the negative (NEG, N, −) terminal. If you
are unsure, first refer to the vehicle owner's manual. Make sure the negative battery terminal is
also connected to the vehicle frame.
5. If engine was recently cranked, use a non-conductive material (cardboard or a folded
newspaper) to wave away (dispel) explosive gases. Do this for a few minutes before any
vehicle connections.
6. Remove the jumpstarter clamps from the storage posts.
 Never allow clamps (positive & negative terminals) to touch together or contact the same
piece of metal to prevent short-circuits and arcing�
7. Securely connect the positive (+) red clamp to the positive (POS, P, +) terminal of the vehicle
battery or the remote positive (+) terminal if equipped.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
1
terminal.
Disconnect negative
(black) clamp
from frame.
©2018 Wagan Corporation. All Rights Reserved.
2
2. Connect negative (black)
clamp to solid metal ground
on engine or frame, away
from battery).
Disconnect positive
2.
(red) clamp from positive
battery terminal.
2
9