Descargar Imprimir esta página

Jackery Explorer 2000 Pro Manual Del Usuario página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

GB
The solar panel charging output unit port (DC8020 male):
When charging, plug this port into the DC input port of the Jackery Explorer 2000 Pro.
The solar panel charging input port (DC8020 female):
When charging, connect solar panel(s) to this port.
The change-over switch for changing from two to three solar panels in series:
When connecting two solar panels to charge, the switch should be kept OFF, otherwise it
cannot be charged. If the switch is ON, three solar panels need to be connected at the same
time to use it.
How to Use (Take 200W Solar Panel As An Example)
Jackery SolarSaga solar panels (68W, 100W and 200W) are equipped with 2 port types at the output
interface. Please refer to the following illustrations to connect the solar panel and the adapter.
When connecting two 200W solar panels, please operate as follows:
SolarSaga 200
When connecting three solar panels, please operate as follows:
SolarSaga 200
Connection Operation Instructions:When charging, please connect the connector to the DC input
port of the power station before connecting the solar panel. When the power station is fully charged,
make sure to remove the solar panel first, then remove the connector from the power station.
07
DC8020
DC7909
SolarSaga 200×2
SolarSaga 200×3
Explorer 2000 Pro
Explorer 2000 Pro

Publicidad

loading

Este manual también es adecuado para:

Je-2000a