Fein GRIT GIS 75 Instrucciones De Uso página 11

3 94 10 013 000 - GB Seite 11 Mittwoch, 15. November 2006 2:49 14
GIS 75
The workpiece must always lie securely on the
grinding rest and the stop. Workpieces that are
too small or too thin may not be worked. Danger
of injury from workpieces being thrown from
the machine.
Never touch the running grinding belt. Dan-
ger of injury.
Press the emergency-off switch immediately in
danger situations. The machine runs on for up to
50 seconds.
Clean the ventilation slots of the machine regu-
larly. The motor fan draws dust into the housing.
Excessive accumulation of metal dust can cause
electrical dangers.
Ensure that the machine is positioned securely
and horizontal. Serious injuries can be caused if
the machine tips over during operation.
The mains plug of the machine may be mounted
only by a qualified electrician. The protective
conductor in the mains socket outlet must be
connected with the protective earthing of the
mains supply.
Pull out the mains plug for maintenance and
repair! Switching the machine on unintentionally
can lead to serious injuries.
Have the electrical safety of the machine checked
regularly in accordance with statutory regula-
tions. For machines that have not been checked,
there may be danger of electrical shock!
Check the rotation direction of the motor before
starting the operation of the machine for the first
time. If the rotation direction of the motor is
incorrect, the workpiece can be thrown from
the machine and cause an accident. The rotation
direction may be changed only by a qualified
electrician.
Make sure that you or other persons are not
standing directly next to the grinding belt when
switching the machine on. The grinding belt can
tear apart and cause serious injuries.
At a glance.
1 Protective cover, top
2 Star-knob bolt for protective cover
3 Stop
4 Spark guard
5 Spark guard wing bolts
6 Grinding rest
7 Dust collector
8 Star-knob bolt for dust box
9 Star-knob bolt for grinding rest
10 Adjustment screw for face- grinding rest
11 Belt tension lever
12 Emergency OFF pushbutton
13 Star-knob bolt for adjusting the tracking of the
grinding belt
14 Plug
15 Ventilation slots
16 On/Off switch
17 Contact wheel
18 Face- grinding rest
19 Drive wheel
20 Screw for side cover
21 Side cover
22 Connection sleeve for dust extraction
23 Instruction label
Intended use of the machine.
The machine is intended for stationary sanding/
grinding of metal materials using manufacturer
approved grinding belts.
EN
11