Descargar Imprimir esta página

Craftsman 247.204122 Manual Del Operador página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting the Battery Cables
Battery posts, terminals, and related accessories contain lead and lead
compounds, chemicals known to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
When attaching battery cables, always connect the POSITIVE (Red) wire to
its terminal first, followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment may have been left
disconnected from the terminals at the factory. To connect the battery cables,
proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The negative battery
terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip ahead to step 2.
1.
Remove the plastic cover, if present, from the positive battery terminal and
attach the red cable to the positive battery terminal (+) with the bolt and
hex nut. See Figure 3.
2.
Remove the plastic cover, if present, from the negative battery terminal and
attach the black cable to the negative battery terminal (–) with the bolt and
hex nut. See Figure 3.
3.
Position the red rubber boot over the positive battery terminal to help
protect it from corrosion.
NOTE: If the battery is put into service after the date shown on top or side
of battery, charge the battery as instructed in the Service and Maintenance
section of this Operator's Manual prior to operating the riding mower.
WARNING
CAUTION
Figure 3
ASSEMBLY
Lower Deck Discharge Chute Deflector
Never operate the mower deck without the chute deflector installed and in
the down position.
The discharge chute deflector must be installed before operating the mower.
1.
Remove the keys that are attached with a zip tie to the chute bracket.
2.
Remove the flange lock nut and hex screw from the deck.
3.
Place the chute deflector on the deck, be sure to insert the tabs on the chute
deflector into the holes on the deck. See Figure 4.
5
4.
When the tabs are installed in the deck, slide the chute deflector toward the
rear of the tractor until the bolt hole in the chute deflector aligns with the
hole in the deck. See Figure 4.
5.
Secure the chute deflector in place with the flange lock nut and hex screw
removed in step 2. Tighten to 102-124 in-lbs. See Figure 4.
9
WARNING
5
4
3
4
Figure 4

Publicidad

loading

Este manual también es adecuado para:

247.204120Z600017akcacs299