Publicidad
Idiomas disponibles
Idiomas disponibles
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box and place
it on the floor as shown in Fig.1.
Make sure that all of the pieces are
there: (1) Main structure; (4L) side bar
(left); (4R) Side bar (right); (15) Allen
screw
M8x30;
M8x30; (55) Allen screw M8x55; (31)
End cap; (7) Monitor; (40) Safety key;
Allen key 5mm; Allen key 6mm; (80)
Holder; (90) Bottle of lubricant.
Follow the instructions step by step to
assemble:
1 First of all take the right side bar
(4R) connect terminals (77) (78) Fig.2,
then insert the side bar (4R) into the
bottom right-hand support on the
structure and use screws (15) (55).
2 Now take the left side bar (4L) and
insert it into the bottom left-hand
support on the structure and use
screws (15) (55) to secure it.
3 At least two people are needed for this
step. When fitting the side bars, one
person should hold the side bar while
the other one fits the screws (15) (55).
This will prevent any possible accidents.
Fig.B
(91)
Allen
FITTING THE MONITOR:
4 Connect the control cable terminal
(79) Fig.3, coming out of the monitor, to
the control cable (77), sticking up from
the right-hand side bar (4R), and insert
screws (15) and (91), making sure not
to pinch the cables, and screw in until
hand tight.
Note: Make sure that the cables do
not become caught up when the unit is
folded. Tighten the 4 screws (15) and
(91) fully. Place the cap (31) on the
screws (91).
Insert the pins of the support (80) into
the holes of the monitor (7), Fig. 3.
5 LUBRICATION.-
CAUTION: Before the first use,
apply approximately half the bottle
of lubricant in the central part of the
screw
belt, along the entire board, and on
both sides as shown in Fig.6.
An illustrative video about lubrication is
available on BH Youtube channel:
https://www.youtube.com/c/BHFitnessS
ervice/videos.
Important notes:
If the bottle of lubricant is missing in
the box, please ask for it before
using an inappropriate lubricant.
Pay special attention to lubricate the
area where you place your feet
during the exercise.
After lubrication, start a program
without anybody using the machine
so
lubricates properly. If you lubricate
after exercise (the belt and the band
still warm), the lubrication will be
even better.
16
that
the
belt
moves
and
Publicidad
