Ryobi P326 Manual Del Operador página 10

REMOVING NAILS FROM THE TOOL
See Figure 10, page 13.
WARNING:
Remove the battery pack before removing nails or
clearing a jammed nail. Failure to do so could result in
serious personal injury.
 Remove battery pack from the tool, if installed.
 To remove a strip of nails from the tool, hold the finish
nailer by the handle with your right hand, and rest your
left hand underneath the tool with your left thumb on the
pusher.
 Depress the release button and slide the pusher all the
way to the rear of the magazine until it locks in place.
NOTE: Always keep fingers clear of nail track of magazine
to prevent injury from unintended release of the pusher.
 Slide the nails toward the back of the magazine and
remove.
OPERATION
CLEARING A JAMMED FASTENER
See Figure 11, page 13.
WARNING:
Remove the battery pack from the tool before clearing a
jammed fastener. Failure to do so could result in serious
personal injury.
Driving too deeply into the material, excess debris, or jammed
nails may lead to the driver mechanism being stuck at its
bottom position.
The driver mechanism can usually be returned to its operating
position by depressing the work contact element against a
scrap piece of wood and squeezing the trigger.
If this does not automatically return the driver mechanism
into the tool, the tool may be jammed.
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
 Remove battery pack from the tool.
 Remove fasteners from the tool.
 Pull up on the latch and open the jam release.
 Insert a flat blade screwdriver into the tip of the driving
mechanism and push the driver mechanism back, freeing
the nail jam.
 Remove the bent nail.
 Close the jam release and latch.
 Reinstall nails.
 Reinstall the battery pack and reactivate tool.
10 — English