Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Finish and Trim (Interior and exterior)
Door & Window Casing
Door Jambs
Baseboard
Crown Molding
Cabinetry
Cap and Shoe Molding
Molding
Staircases
Door and Window Trim
Chair Rail
Brickmold
Hardwood Flooring
Paneling
Furniture
ATTACH BELT CLIP
See Figure 1, page 12.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
Align belt clip and screw with right or left side screw hole.
Using a phillips head screwdriver (not included) tighten
securely.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 12.
To install battery pack:
Place battery pack in the tool. Align raised rib inside tool
with groove on battery pack.
Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool before
beginning operation.
NOTE: Squeeze LED worklight grip switch to reactivate
nailer.
To remove battery pack:
Locate latches on battery pack and depress to release
battery pack from the tool.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
NO-MAR PAD
See Figure 3, page 12.
The no-mar pad attached to the nose of the tool helps prevent
marring and denting when working with softer woods.
WARNING:
Remove the battery pack from the tool before removing
or replacing the no-mar pad. Failure to do so could result
in serious personal injury.
The pad can be removed by pulling it down and away from
the nose. To replace the pad, fit it into place over the nose
and push up at the back to reseat.
On-board storage for the pad is located on the magazine of
the tool. An extra no-mar pad is provided in the on-board
storage area.
LOADING THE TOOL WITH NAILS
See Figures 4 - 5, page 12.
Remove battery pack from the tool, if installed.
Depress the release button and slide the pusher all the
way to the rear of the magazine until it locks in place.
With the nose of the tool pointed away from you, feed
a strip of nails into the magazine. Be sure the nails are
pointed downward and at the angle shown.
WARNING:
Keep the tool pointed away from yourself and others
when loading nails. Failure to do so could result in
possible serious personal injury.
Press the release button to release the pusher and allow it
to push the nails up to the driving mechanism. The pusher
will stop when it rests against the end of the nail strip.
NOTE: Do not allow the pusher to snap back into place.
8 — English
Publicidad
