RIDGID RD907500P Manual Del Operador página 18

ASSEMBLY
 Place a washer on the axle bolt, then slide the axle bolt
through the bracket on the frame.
 Place a second washer on the axle bolt then install a hitch
pin to secure.
 Repeat the process on the other side to install second wheel.
CONNECTING BATTERY
See Figure 7.
WARNING:
To reduce the risk of electrocution or explosion, do
not short circuit the battery terminals or charge in a
sealed container. Keep sparks and flame away.
WARNING:
Keep metal objects away from the battery terminals.
Metal objects can make a connection from one
terminal to another. Shorting the battery terminals
together can cause sparks, burns, or a fire.
OPERATION
DANGER:
Carbon Monoxide. Using a generator indoors CAN
KILL YOU IN MINUTES.
Generator exhaust contains high levels of carbon
monoxide (CO), a poisonous gas you cannot see or
smell. If you can smell the generator exhaust, you
are breathing CO. But even if you cannot smell the
exhaust, you could be breathing CO.
 Never use a generator inside homes, garages,
crawlspaces, or other partly enclosed areas.
Deadly levels of carbon monoxide can build up
in these areas. Using a fan or opening windows
and doors does NOT supply enough fresh air.
 ONLY use a generator outdoors and far away
from open windows, doors, and vents. These
openings can pull in generator exhaust.
Even when you use a generator correctly, CO may
leak into the home. ALWAYS use a battery-powered
or battery-backup CO alarm in the home.
If you start to feel sick, dizzy, or weak after the
generator has been running, move to fresh air
RIGHT AWAY. See a doctor. You could have carbon
monoxide poisoning.
The battery cables must be connected before the electric start
feature of the generator can be operated.
 Connect the red wire to the positive (+) terminal first, then
connect the black wire to the negative (−) terminal using the
screws, nuts, and washers provided. Make sure all connec-
tions are tight.
NOTE: Be careful not to short across the terminals when
installing. Shorting the terminals together can cause sparks,
damage to the battery or generator, or even burns or explo-
sions.
 Cover the terminals with the rubber covers.
When removing the battery for replacement: Remove the
nut and bolt first from the negative (black) post, then from the
positive (red) post, being careful not to short across the termi-
nals. Always abide by the safety warnings provided with the
battery. Remove the battery and dispose of according to local
and state regulations.
WARNING:
If this generator will be used only with cord and
plug-connected equipment, National Electric
Code does not require that the unit be grounded.
However, other methods of using the generator
may require grounding to reduce the risk of shock
or electrocution. Consult a qualified electrician,
electrical inspector, or local agency having
jurisdiction for local codes or ordinances to find
out if grounding is needed in your situation before
using the generator.
WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
12 — English