Publicidad
Voltage measurement (AC / DC)
1.
Set the rotary switch to the position V~ or V=
2.
Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the multi-function jack.
3.
Touch the measuring points with the probe tips.
4.
Once
the
DC: If the polarity is reversed a "Minus sign" is displayed.
Non Contact Voltage tester (NCV)
(only AC!)
1.
Set the rotary switch to the position NCV
2.
Hold the top of the meter to an electrical outlet or cable (<5 mm). When it
comes to alternating voltage, the LED display (3) lights up.
At low alternating voltage - or greater distance - the indicator shows "L"
(low), the green LED lights up and a beep sounds.
At higher alternating voltage, the display shows "H" (high), the two red LEDs
light up and a higher signal sound sounds.
Attention!
Even without an alarm, dangerous voltage can be concerned! This depends on
various factors. Therefore, if necessary, check the zero voltage with the
voltmeter.
DC current measurement (DC)
(Alternating current measurements are not possible.)
1.
Set the rotary switch to the position A= (2000 µA or 200 mA)
2.
Attach the pin-plug of the black test lead to the COM-jack and the pin-plug
of the red test lead to the multi-function jack.
3.
For measurements up to 10 A set the rotary switch to the 10 A-Position and
attach the pin-plug of the red test lead to the A-jack.
reading
stabilizes,
31
read
the
English
value.
Publicidad
