Publicidad
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
Connecting with an XLR cable (N-70AE only)
The signal is converted to analog in the D/A converter of
this unit and then output to an integrated amplifier, for
example. Connect the XLR input jack on an integrated
amplifier with an XLR cable to the ANALOG OUT jack (XLR
jack) on this unit.
Connecting with a digital optical cable
The signal is converted to analog in the D/A converter of the
integrated amplifier, for example. Connect the OPTICAL IN
jack on an integrated amplifier with a digital optical cable to
the DIGITAL OUT OPTICAL jack on this unit.
0 The digital signals that can be output by this unit are
linear PCM signals with a sampling frequency and
quantization bit rate of 192 kHz/24 bit (operation may not
be possible with all connected devices or environments).
a Monaural Miniplug Cables (without resistors)
10
> Install
> Initial Setup
Connecting with a digital coaxial cable
The signal is converted to analog in the D/A converter of the
integrated amplifier, for example. Connect the COAXIAL IN
jack on an integrated amplifier with a digital coaxial cable to
the DIGITAL OUT COAXIAL jack on this unit.
0 The digital signals that can be output by this unit are
linear PCM signals with a sampling frequency and
quantization bit rate of 192 kHz/24 bit (operation may not
be possible with all connected devices or environments).
The control jack
By connecting Pioneer brand amplifiers or CD players, for
example, that have control jacks using monaural miniplug
cables (without resistors), you can centralize control of the
devices using the Pioneer Remote App.
Furthermore, even when the other devices are put in places
where the remote control signal is unable to reach, you can
enable operation of the other components through the
remote control sensor of this unit.
0 Also make sure to connect with the analog audio cable.
Centralized control cannot work correctly with only the
control jack connection.
0 With this connection, the remote control sensors on the
amplifier and CD player stop working. Point the remote
controller at remote control sensor of this unit.
> Playback
Supplementary information | Advanced Setup | Others
This unit
a
a
E
N
IN
OUT
CONTROL
Amplifier
IN
OUT
CONTROL
CD player
Publicidad
