Aurora WM830XA Manual De Instrucciones página 5

MAINTENANCE
 Warning: Failure to properly maintain your shredder will void the warranty.
 Oil the shredder blades every month with basic vegetable, cooking oil or shredder oil. Follow oiling
procedure below (FIGURE 6). It helps to keep the shredder blades operating well over many years of
use.
FIGURE 6
Shredder
Oil
DO NOT USE
AEROSOL PRODUCTS!
 CLEANING:
• ALWAYS UNPLUG THE SHREDDER BEFORE CLEANING!
• Only clean the shredder by carefully wiping the unit with a dry soft cloth or towel.
• Do not clean or immerse shredder in water. Having the unit wet may result in damage or malfunction to
the electrical components. If the shredder happens to get wet, be sure to completely dry the unit immedi-
ately with a cloth or towel.
• Never use anything flammable to clean the shredder. This may result in serious injury or damage to the product.
8 ENGLISH
Oiling procedure:
1. Turn off shredder.
2. Apply shredder oil across paper entry.
3. Turn shredder in reverse mode for 3~5 seconds.
!
Caution:
• Do not spray or keep any aerosol products
in or around shredder.
• DO NOT USE CANNED AIR ON SHREDDER.
TROUBLESHOOTING
If there is a problem with your shredder, check below for the symptoms and steps to resolve. If you
continue to have problems, contact customer support at our Service Center 1-800-327-8508. DO
NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. This will completely void the
product warranty.
The shredder does not work at all.

1) Make sure the unit is plugged in and that the outlet is in good working order.
2) Overheating with extended use: In the event that the shredder has shred continuously
beyond the maximum running time and overheated, the unit will automatically shut off. If this hap-
pens, switch the shredder Off for 30 minutes or longer before resuming normal operation.
3) Make sure the shredder head is correctly seated onto the included wastebasket, with all the words
and icons facing towards you. The head unit is particularly designed to work only with the integrated
FIGURE 7
4) Be sure NOT to open the cover beyond the preset position, otherwise the ShredSafe™
feature will be activated and the shredder will be inoperable. The "SHREDDER STATUS" indication line
must align with the "READY" setting.
Cover over tilt
5) If using a plastic bag to line the wastebasket, please remove it. This may cause the shredder not to
operate properly.
6) The activation sensor of the shredder is located near the center of the feed slot. Be sure to feed
directly into the center area to activate the machine (especially applies to smaller pieces of paper
or credit cards).
wastebasket. Aurora shredders are equipped with a
safety interlocking mechanism, which prevents the shred-
der from working when the head unit is lifted, removed,
or accidentally knocked over. On the back center edge of
the shredder head, next to the power cord, is a "curved
flap-like shape" that MUST FIT OVER THE OUTSIDE of
the wastebasket. The shredder will not function unless the
head unit is properly mounted as pictured. (FIGURE 7)
Disabled position
Ready position
CONTINUED NEXT PAGE
ENGLISH 9