KitchenAid KSM7581MS Instrucciones página 15

All manuals and user guides at all-guides.com
• Unplug the Stand Mixer before
cleaning or disconnect power.
• Stainless steel bowl, flat beater,
wire whip, and spiral dough hook
may be washed in an automatic
dishwasher. Or, clean them thoroughly
in hot sudsy water and rinse completely
before drying. Do not store beaters on
shaft.
• The bowl is dishwasher-safe. It can
also be hand-washed in hot sudsy
water, rinsed thoroughly, and dried.
• Wipe the Stand Mixer with a clean
damp cloth. Do not use abrasive
cleansers or scouring pads and do
not immerse the Stand Mixer in
water.
• Wipe the beater shaft frequently,
removing any residue that may
accumulate.
To remove the Bowl Support
for cleaning
1. Unplug Stand Mixer or disconnect
power.
2. Remove the Stand Mixer base by
removing the 3 screws located on
the bottom of the mixer. Remove
the vent screen and the mixer base.
Care and Cleaning
3. Remove the nut from the lifter rod
located inside the column, then remove
the washer and spring.
NOTE: Note the order that they were
assembled (the washer goes between
the spring and nut), for reassembly.
4. Loosen the screw holding the
bowl clip to the front of the bowl
support – it is not necessary to
remove the screw all of the way.
This allows the bowl support to
slide down.
Screws
Screw
Nut
15