Publicidad
Idiomas disponibles
Idiomas disponibles
Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
Starting Operation
Observe correct mains voltage! The voltage of the power source must agree with the voltage
speci ed on the type plate of the power tool.
Switching ON and o
To start the power tool, press the on/o switch 6 and keep it pressed.
To lock the pressed on/o switch 6,push the lock-on button 4 upward.
Sharpening chisels
Good results are only achieved with sharp chisele; therefore, sharpen the chiseling tools in
good time. This ensures a long service life the tools and good working performance.
Re-sharpening
Sharpen chiseling tools using grinding wheel (e.gceramic bonded corundum wheel)with a
steady supply of water, Reference valuces are shown in the gure. Take care that no annealing
coloration appears on the cutting edges; this impairs the hardness of the chiseling tools.
For forging heat the chisel to between 850 and 1050°C (right red to yellow)
For hardening, heat the chisel to approx 900°C and quench in oil. Then anneal in an oven for
approx, one hour at 320°C.
Maintenance and Cleaning
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and the ventilation slots clean.
A damaged dust protection cap should be changed immediately. We recommend having this
carried out by an after-sales service.
Lubrication
The power tool is oil-lubricated. An oil chang is required only within the scope of maintenance
or repair through an authorized after-sales service agent for Siefken power tools. in this it is
absolutely required to use the speci ed Siefken oil If the power tool should fail despite the care
taken in manufacturing and testing procedures, repair shoulu be carried out by an after-sales
service center for power tools.
9
Publicidad
