Descargar Imprimir esta página

SG Group MG3000i Instrucciones De Uso página 59

Publicidad

Idiomas disponibles

Idiomas disponibles

6 When you want to stop the generator, press the "STOP" button on the remote
control according to the lower figure.
IMPORTANT FOR REMOTE CONTROL USE:
When the generator is off and the remote receiver active (waiting for the start
signal) there is a power consumption. This small consumption is supplied by the
generator battery.
This consumption could totally discharge the battery. To
avoid, if the generator is left inactive for 12 hours (without starting), the battery
will
be
automatically
To reactivate the battery and therefore to restart the remote control system it
will be necessary to press "ACTIVATE BATTERY" again on the control panel.
SYNCHRONIZING NEW CONTROLLERS
1. Turn the engine switch to "ON" position.
2. Press one time "RESTAR RECEIVER" button.
3. Press and keep press "RESET" button place in panel control, untill
"PILOT LAMP" lights.
4. Presione "START" button in controller, then "PILOT LAMP" in control
panel will flash, then press again once the "START" button, the
generator start the startup process and the new controller is
synchronizing.
TOTALLY REMOTE SYSTEM RESTORE
If the remote start up system fails or work abnormally.
1. Place engine switch in "OFF", then pass to "ON".
2. Push "RESTART RECEIVER".
disconnected
to
56
prevent
its
discharge.

Publicidad

loading

Productos relacionados para SG Group MG3000i