Bollhoff RIVKLE B2007 Manual De Uso página 35

1. Adjust roughly a distance of 22,5 mm between the front side of the fork and the driveshaft.
2. Then, install the mandrel and test to optimise the position of the fork:
• Always ensure the installation/remove of the mandrel
• Reduce as much as possible the axial mechanical clearance of the mandrel inside the fork
3. Tighten the counter nut for fixing the position with a torque of 10Nm.
THE BATTERY HAS TO BE DISCONNECTED WHEN REPLACING THE TOOLING.
MANDREL (1) MOVES DURING USE. AVOID CONTACT AND PAY THE UTMOST ATTENTION.
Mandrel
A
C
Fork
• Remove the mandrel
• Refit the new mandrel
(see in figure 4).
CAREFULL: grease (Multipurpose grease) has to be applyed between fork
• Reposition the nose
• Retighten the nose
• Screw the new anvil
to the nut.
Figure 3 - Fork and nose for studs & force >18 kN (M8 & M10)
Figure 4 - Mandrel alignement
OK
E
by taking care to align the back side groove with the screwing driver
to 15 Nm.
inside the nose and lock it after adjusting the correct position thanks
Nose
B
Pos. 23616600213
D
OK
(22,0 —> 24,0 mm)
< >
Force: 10 Nm
OK
Anvil
and mandrel .
35