AEG IKE64443FW Manual De Instrucciones página 18

Problem
and a number come on.
8.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
9. TECHNICAL DATA
9.1 Rating plate
Model IKE64443FW
Typ 61 B4A 01 AD
Induction 7.2 kW
Ser.Nr. .................
AEG
9.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Left front 2300
Left rear 2300
Right front 1400
Right rear 1800
The power of the cooking zones can be
different in some small range from the data in
the table. It changes with the material and
dimensions of the cookware.
18 ENGLISH
Possible cause
The diameter of the bottom of the
cookware is too small for the zone.
There is an error in the hob.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The information about
guarantee period and Authorised Service
Centres are in the guarantee booklet.
PNC 949 597 453 00
220 - 240 V / 400 V 2N 50 - 60 Hz
Made in: Germany
7.2 kW
PowerBoost [W]
3200
3200
2500
2800
For optimal cooking results use cookware no
larger than the diameter in the table.
Remedy
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 125 - 210
10 125 - 210
4 125 - 145
10 145 - 180
comes