Publicidad
Idiomas disponibles
Idiomas disponibles
START OPERATION
1. Place the product in an upright position on a fl at, stable, and heat-resistant
surface. Make sure there is nothing fl ammable or heat sensitive within 39
inches (100 cm). Operating the product in any other position could cause a
hazard.
2. Insert the plug into a suitable wall socket. The dehumidifi er is suitable for
operating on an electricity supply having the same voltage as that shown on its
rating label.
3. Make sure the water tank is correctly positioned. After switching the unit on for
the fi rst time, if the ``Bucket Full`` light illuminates, pull out the water tank and
check that the ``fl oat`` lever is able to move freely. Then return the water tank
to the correct position (Fig. 1).
WATER FULL
INDICATOR LIGHT (RED)
When the bucket is full and/or incorrectly positioned inside the cabinet, the water full red light turns on and remains on
until such time as the bucket is emptied and/or correctly re-positioned. This condition will result in the immediate shut
down of the dehumidifying system (both compressor and fan motor operation are terminated). This is a safety feature.
When the bucket is emptied and/or correctly re-positioned, the dehumidifi er will resume operation automatically.
NOTE: It may take several minutes before operating conditions resume.
The water tank should be carefully removed from the machine by sliding it outward from the
front of the unit, and it should be emptied. When the empty tank is replaced properly in the
machine, the unit will start up and run normally (Fig. 2).
NOTE: Please use both hands to carefully empty the water tank.
DEHUMIDIFYING
Dehumidifying is a means of removing moisture from the air. A dehumidifi er will help to protect your home and valued
possessions from damage (swelling) caused by moisture in the air. Essentially a dehumidifi er removes moisture from the
air as the moist air passes over a dehumidifying (evaporator) coil. Moisture is condensed on the evaporator coil, drained,
and collected inside an internal (removable) water tank located at the front of the unit. The exhausted air being returned
into the room environment is elevated several degrees, causing the surrounding air temperature to increase
(slightly). This process also contributes to lowering the relative humidity of the surrounding air.
DEHUMIDIFYING MODE SELECTION:
1) To turn the unit on, press the ON / OFF button.
2) Press the humidity
FAN SPEED SELECTION:
Select a fan speed on the keypad. The speed you select is identifi ed by the (illuminated) indicator light located directly
above the selection made.
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
or
buttons to select a desired RH operating value (30%-90%).
6
Publicidad
