cecotec CONGA 890/SLIM Manual De Instrucciones página 21

NOTE:
• Please make sure that the power switch has been turned on. Otherwise, the machine will not
be able to operate or charge.
• If the light is green and produces an alarm sound when being charged, it indicates that the
bottom power switch of the machine has not been turned on and the machine cannot be
properly charged.
• Make sure that the power switch is on before charging. Otherwise, the machine will not be
properly charged.
• If the machine is not to be used for a long time, please charge the machine completely, turn
off the power switch, remove the battery and store it in ventilated and dry places.
Side brush installation
Place the side brushes at the bottom of the appliance as shown in the image. Please, make sure
they are properly fixed.
POWER ON
• Turn on the switch on the robot's side.
WARNING: the robot vacuum cleaner is equipped with an ON/OFF switch on its main body. As
a safety system, if the robot is switched OFF, all preset values will be restored. If you want the
robot vacuum cleaner to be programmed at a specific time, the switch must always be ON,
otherwise, you will need to programme the robot again from the remote control.
POWER ON/STANDBY/HIBERNATION/POWER OFF
POWER ON
• Make sure that the power switch at the bottom of the machine is turned on.
• Press the
STANDBY MODE
• Press the
• Hold the button for 3 seconds to enter this mode while in hibernation mode.
HIBERNATION MODE
• Hold the button of the machine for 3 seconds.
• The machine will automatically enter this mode if there is no operation for 30 seconds.
05137_Conga Slim 890_Manual_PE/LI.indd 21
In order to charge the appliance, keep the switch on ("I" on). This way the
battery will be fully charged for the next use.
"I" on, "O" off
button on the machine or the remote control to start the machine.
button to enter this mode while in cleaning mode.
ENGLISH
CONGA 890 SLIM 21
31/5/18 11:25