Aprimatic R223 Instrucciones De Uso Y El Mantenimiento página 15

Fix the back plate to the
Pillar(FIG.1)
Anchor the rear part of the piston
to the plate and faste nit firmly (FIG.2)
Warning! When establishing the height off the ground at which to fasten the plate to the post
(FIG.1), keep in mind that the plate for anchoring the piston to the gate must be fastened at the
same level (FIG. 3)
1 Fit the anchor plate onto the piston (FIG. 4)
2 Close the gate.
3 Move the piston with the plate already fitted towards the gate
4 Move the fitting to limit stop, then move it back by approximately 1 cm and mark the
position of the plate.
5 Realize the same operation in opening.
6 If positions correspond, fix the plate on the gate; otherwise revise A and B units (table 1)
INSTALLATION OF FASTENING PLATES
Installing the anchor plate on the piston to the gate
R223
15