Fermax VEO XL Guia De Inicio Rapido página 8

START GUIDE FOR DUOX PLUS WIFI VEO XL MONITOR
CONTROL BUTTONS
Inductive loop label
(depending on the
model)
F2
The white line at the bottom of the icon indicates the function that is currently in effect.
Select with
To perform a quick reboot of the terminal, press and hold the menu button for 10 seconds.
HOW TO PROGRAM WIFI VEO XL MONITOR
1. INSTALL
Monitor powered for the first time.
The blue led blinking slowly indicates that the monitor has not been
programmed.
2. ENTER PROGRAMMING MENU
Press the
PROGRAMMING FROM THE PANEL
PROGRAMMING MENU
Select the
Enter the calling code for this monitor from the panel (calling code for this monitor). A different call tone
sounds, confi rming the monitor´s programming. After a few seconds the monitor returns to standby.
"The programming of the card must be done from the MASTER card". To configure the card as
MASTER, please refer to the manual of our DUOX PLUS cards Cod.970049.
2
DUOX PLUS WIFI VEO XL MONITOR
Digital menu for internal parameter settings and configuration.
(When the monitor has already been programmed)
In conversation, press to open the door.
In standby, call to guard unit (if applicable).
Auxiliary function, (contact your installer).
In standby, press and it displays the option of auto-on with
different panels. By sequentially pressing Panel 0, Panel 1,
General Panel, (depending on the available panels).
Audio activation and hang-up (hands-free functions).
Potentiometer. Ring tone volume setting.
• On standby: Melody volume.
• Conversation in progress: Upstream audio setting.
99
/ the desired icon and confirm with
button to access the «programming menu».
icon and confirm with
WIFI VEO XL monitor incorporates an OSD menu that is
managed via the monitor´s push buttons. The icons displayed
are managed with the corresponding buttons located on the
monitor.
.
, (you hear a beep in the monitor).
Cod. 970194b V05_23