Flex FX1681 Manual Del Operador página 12

CHUCK KEY STORAGE
Your tool features a chuck key holder on the
bottom of the tool. To prevent loss, return the
chuck key into the chuck key holder after each
use (Fig. 6).
To install the chuck key into its holder
Insert the chuck key vertically into the holder
and the flat head into the groove as shown
in Fig. 7. Snap the handle of the key into the
retention clip on the holder. Tilt the chuck key
flat and snap the shaft of the key into the groove
(Fig. 7).
To remove the chuck key from its holder
Lift the chuck key forward and pull the chuck
key handle out of the holder.
NOTICE: To avoid losing the chuck key, do not
store it in any other orientation.
Fig. 6
Fig. 7
Flat
Head
-12-
Shaft
Chuck Key
Holder
Handle