Flex FX1681 Manual Del Operador página 14

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located in front of the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool for forward rotation
(Fig. 10).
b. Position the direction-of-rotation selector to
the far right of the tool for reverse rotation
(Fig. 10).
c. Position the switch in the "OFF" (center-
lock) position to help reduce the possibility of
accidental starting when not in use.
SPEED CHANGE KNOB
WARNING
a complete stop. Changing the tool speed
before the tool stops may damage the tool.
NOTICE: Always set the speed change knob
carefully into the correct position. Operation of
the tool with the speed change knob positioned
half-way between the positions "H" and "L" may
damage the tool.
Two speed ranges can be preselected with the
speed change knob.
To change the speed mode
With the tool stopped, push the release button in
the direction of the arrow, and then turn the speed
change knob to the desired speed mode (Fig. 11).
Align the side of the knob marked "L" with the
triangular indicator for low speed / high torque
mode or the side marked "H" for high speed / low
torque mode.
ADJUSTMENTS
After tool use, lock the
direction-of-rotation
Use the speed change knob
only after the tool comes to
Fig. 10
NOTICE: To prevent gear damage, always
allow the tool to come to a complete stop before
changing the direction of rotation.
NOTICE: The tool will not run unless the
direction-of-rotation selector is engaged fully to
the left or to the right.
Fig. 11
Arrow
Release
Button
-14-
Indicator
Speed Change Knob