BIG ASS FANS 0-10 V Manual De Instrucciones página 6

6. Wire module
Wire the module as shown.
Light 0–10 V Input Channel
Violet (+)
2
Gray (-) 2
Violet (+) 2
Gray (-)
2
Fan 0–10 V Input Channel
1. Input signal is job dependent and could
be a 0–10 V wall dimmer or automation
controller supplying a 0–10 V signal.
2. Solid or stranded wire: 20–14 AWG /
0.518–2.08 mm
2
3. The number of fans that can be daisy
chained depends on the 0–10 V
controller load. Big Ass Fans does not
recommend daisy chaining more than
ten fans to one controller.
7. Install module
Peel the backing off the double-sided tape on the module, and then affix the
module to the mounting bracket in the location shown. Make sure the module
will not interfere with canopy installation.
4
© 2022 DELTA T LLC
1
1
ALL RIGHTS RESERVED.
Installations with BAFCon
bigassfans.com/docs/bafcon/bafcon-0-10-V-installation.pdf
Daisy chain to additional fans
BAF-INST-388-MUL-01 REV. A
3
10/12/2022