Ibiza Light MHBEAM40-FX Manual De Instrucciones página 3

MANUAL - MHBEAM40-FX
3. DMX SET UP
Notice: Be sure to follow figures two and three when making your own cables. Do not use the ground lug on the
XLR connector. Do not connect the cable's shield conductor to the ground lug or allow the shield conductor to
come in contact with the XLR's outer casing. Grounding the shield could cause a short circuit and erratic beha-
vior.
Special Note: Line Termination. When
longer cable runs are used, you may
need to use a terminator on the last unit
to avoid erratic behavior. A terminator
is a 110-120 ohm 1/4W resistor which
is connected between pins 2 and 3 of a
male XLR connector (DATA + and DATA
-). This unit is inserted in the female XLR
connector of the last unit in your daisy
chain to terminate the line. Using a cable terminator will decrease the possibilities of erratic behavior.
4. MENU:
4.1 DISPLAY:
LED Display with four buttons: MENU, UP, DOWN, ENTER
4.2 MENU CHART:
3