network connection & setup
You can set up the network settings according to your network configurations.
Network connection and setup processes are given as follows.
Connect the camera to an IP router with a xDSL/Cable modem Page 27~29
Connect the camera to an IP router with local area networking Page 30~31
Connect the camera directly to a DHCP-based xDSL/Cable modem Page 32~33
Connect the camera directly to local area networking Page 34
Compliant IP routers are as listed below.
- Linksys
- D-Link
- Netgear
Compliant PoE Switches are as listed below.
- Linksys SRW224G4P
- D-Link DES-1316
- SMC SMCPWR-INJ3
Do not use other IP routers than the camera authorized ones.
Otherwise, it can cause a network error.
Depending on the performance of the PC (Viewer installed) or the network, the video
transmission can be delayed or even disconnected.
For soft video transmission, you can set the bandwidth in <NETWORK>
<STREAMING SETUP> in the setup menu.
The IP and MAC addresses used in this manual are for illustrative purposes only.
Therefore, you must refer to Notice the network settings of your PC and do not enter the
addresses presented in this manual.
26_
Network Connection & Setup