MUHLER MV-80N Manual De Uso página 5

EN: VACUUM SEALER | Instruction Manual
3. Before assembling, be sure the sponge is dry. During the process of assembling, do not damage it.
4. Dry thoroughly before reusing.
5. It is forbidden to wipe with organic solvents and no need to add lubricant to the machine.
6. When the machine fails, it should turn off the power immediately, check the cause and remove the trouble
TROUBLESHOOTING
Common fault Reason Methods
No reaction while 1. Please check Power cord to see if it is firmly plugged into an electrical
vacuum packaging No electricity outlet.
2. Check whether the power cord is damaged.
1. Check whether the upper and the lower covers are locked.
2. Check the connection between the machine and the container is intact.
Incorrect operation 3. The open end of the bag should be placed in the vacuum channel.
There is debris on
Fails to vacuum
the heating wire and Clean up the debris and wipe it.
sponge
1. Make sure use special bags for vacuum
Bag for leaks There 2. Ensure that the open end of bag is smooth, no wrinkles, no debris, hard
are debris or liquid objects, etc.
3. Examine the bag for leaks.
1. Examine the bag for leaks.
Pressure does not 2. Please check if the sponge is deformed or damaged
reach the preset 3. Make sure place the bag in right place.
Fail to seal after degree
vacuuming
Open end of the bag Please press „Seal" again.
is wet or seal is not
good
Heating wire does Check whether the heating wire has temperature, if no, please ask after-
not work sale service.
Poor sealed
Bag has leakage
Bulge bag
After sealed, the air
goes into the bag again
Food chemistry
Food is hot
Improper operation
8
Ensure the open end of the bag is smooth, no wrinkles, no debris
,etc.
Exam the bag for leaks.
Check to see if the item was bad for Poor preservation
Fresh fruits and vegetables emit gases in photosynthesis, also
fermented foods emit gases, which are not suitable for vacuum
sealing long time.
Cool down the hot food before vacuum sealing it.
The bag is too full to make the bag flat.
EN: VACUUM SEALER | Instruction Manual
The voltage is too high
The sealed bag melts.
Intensely and continuously
using the machine, leads the
heating wire to overheating.
The sealed end of bag is The heating
not tight time is not enough
If all problems has been excluded, please contact us.
If you have not been able to remedy a fault by yourself, do not attempt to
disassemble or repair the appliance yourself. Take it to the nearest manufacturer
authorized service center.
Check whether the voltage is within the applicable range
Stop for a while, allow the machine to cool down.
For thick bags, please long press to ‚,thick bag mode".
9