Descargar Imprimir esta página

SOLAC VICTORIA Instrucciones De Uso página 8

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
(Original instructions)
A - Folding hanger
B - Steam hose and connector
C - Water tank with cap
D - Telescopic rod and connector
E - Protection for delicate fabrics
F - Steam nozzle
G - Drain plug
H - On/off knob
I - On/off indicator
If your model of appliance does not have
the accessories described above, these
can also be purchased separately from
Technical Assistance Services.
-
Before each use, fully extend the power
cord of the appliance.
-
Do not use the appliance if the
accessories or consumables are not
properly attached.
-
Do not use the appliance if the
accessories attached to it are defective.
Replace them immediately.
-
Do not use the appliance if its on/off
switch does not work.
-
Do not operate the appliance without
water.
-
Use the appliance only with water.
-
The use of water with low calcareous
and magnesium mineralization is
recommended, especially if the water
you have at your disposal contains any
type of mud or is of the "hard" type
(containing calcium or magnesium).
-
Do not move the appliance while it is in
use.
-
Do not turn the appliance upside down
while it is in use or connected to the
mains.
-
Unplug the appliance from the mains
before refilling the water tank.
-
Unplug the appliance from the mains
when not in use and before any cleaning
operation.
-
Do not store the appliance if it is still hot.
-
Never leave the appliance switched on
and unattended. This will save energy
and prolong the life of the appliance.
-
Keep this appliance out of the reach of
children and/or persons with reduced
physical, sensory or mental capabilities
or lack of experience and knowledge.
-
Do not use the device on any part of the
body of a person or animal.
As shown in Fig.1 we must first connect
the telescopic rod (D) to the plate.
-
To do this unscrew the connector.
-
Insert the connector into the bar and the
bar into the hole.
-
Screw the connector back on so that the
bar is secured.
As shown in Fig. 2, extend the bar (D)
and insert the folding hanger (A).
-
If we open the tabs of the pole we can
extend the pole.
-
By closing the tabs again, we lock the
pole at the desired height.
-
Insert the snap-on sling bar into the
upper end of the pole.
Following Fig.3 we install the steam hose
(B).
-
Attach the hose with the connector to
the corresponding hole in the iron.
-
Screw the connector so that the hose is
secured.
-
As shown in Fig.4 extend the sling bar
arms (A) by pulling them upwards.
-
NOTE: To fold back the sling bar arms,
simply squeeze the two tabs at the
bottom and fold the arms.
-
Hang the steam nozzle (F) on the holder
at the top of the hanger (A).
-
We can attach the brush (E) to the top of
the steam nozzle (F) under pressure. This
brush allows you to protect the most
delicate fabrics.

Publicidad

loading