Descargar Imprimir esta página

SOLAC VICTORIA Instrucciones De Uso página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
-
Asegúrese de que ha retirado todo el
material de embalaje del producto.
-
Antes de conectar la máquina compruebe
que el mando de encendido/apagado (H)
está cerrado (en posición OFF).
The water tank must be filled before the
appliance can be used.
-
To do this, remove the water tank (C).
-
Unscrew the cap and fill the tank with
water.
-
Screw the cap back on and place the tank
correctly on the griddle.
-
First fill the water tank (C) according to the
"water filling" instructions.
-
Fully extend the cable before plugging in.
-
Plug the appliance into the mains.
-
Turn the on/off knob (H) and select the
desired mode.
-
Wait 45 seconds for the appliance to heat
up.
-
Hang the garment on the folding hanger.
-
Spray the steam on the garment holding
the garment from one end to keep the
fabric taut.
-
OFF: The appliance is switched off.
-
SILK: Ideal mode for delicate fabrics such
as silk.
-
COTTON: Ideal mode for use on cotton.
-
MAX: Perfect mode for removing the most
stubborn wrinkles in non-delicate fabrics.
-
Switch off the appliance using the on/off
switch (H).
-
Unplug the unit from the mains.
-
Wait at least 30 minutes for the unit to cool
down.
-
Empty the water reservoir (C).
-
Unscrew the drain plug (G) and empty
the water reservoir.
-
CAUTION: Screw the drain plug back
into place.
-
Fold the telescopic pole (D) using the
tabs.
-
Unscrew the steam hose (B).
-
NOTE: You can use the steam nozzle
holder to roll up the hose while the
appliance is not in use.
-
Unplug the unit from the mains and allow
it to cool down before cleaning.
-
Clean the unit with a damp cloth soaked
in a few drops of detergent and then
wipe it dry.
-
Do not use solvents, or products with an
acid or basic pH factor such as bleach,
or abrasive products to clean the
appliance.
-
Do not immerse the device in water or
any other liquid, nor put it under the tap.
-
For a perfect operation of the appliance,
it must be free of lime or magnesium
incrustations caused by the use of high
hardness water.
-
To avoid this type of problem, the use of
water with low calcareous or magnesium
mineralization is recommended.
-
Homemade solutions, such as the use of
vinegar, are not recommended for
decalcification treatments.

Publicidad

loading