dBTechnologies VIO S218F Manual Del Usuario página 43

English
HANGING CONFIGURATION
• The DRK-218F flybar is designed to support up to a
maximum of 14 VIO S218F subwoofers with two lifting
points or 10 subwoofers with a single lifting point, in
accordance with the EUROCODE 3 standard (EN 1993-1-1).
• Secure the DRK-218F flybar to the subwoofer (installed on a
level surface). For further details on this accessory, refer to
the complete manual.
• Lift the VIO S218F subwoofers one by one and secure them
• Check that the local parameters of the various subwoofers
are set correctly on the individual amplifier panels.
Alternatively, you can remotely change all parameters in
real time or later if you connect the cluster via the RDNet
network (AURORA NET). However, it is good practice to
physically copy at least the initial design settings onto
the VIO S218F modules before installation. For further
information, see the CONFIGURATION PARAMETERS section
in the corresponding manual.
• Make the audio, RDNet and power supply link connections
as described in the previous paragraphs.
CARDIOID CONFIGURATION
• VIO S218F subwoofers can be stacked in a vertical cardioid
configuration.
• Check that the local parameters of the various modules are set
correctly on the individual amplifier panels. Make the audio,
RDNet and power supply link connection as described in the
previous paragraphs. When powering up, be aware of the
inrush current given in the
electrical system dimensioning, possibility of powering up the
various subwoofers sequentially).
• When using remote control with RDNet and DBTECHNOLOGIES
NETWORK, the local settings are bypassed and the software has
control.
In accordance with the BGV-C1 standard, up to 7 subwoofers can be hung if they have two lifting
points or 5 if they have a single lifting point.
VIO S218F
TECHNICAL SPECIFICATIONS (e.g.
Cod. 420120416 REV. 1.0
43